Introduced to mark Buick’s 50th anniversary, the Buick Skylark (first use of the name for a production vehicle) on one of three specialty convertibles produced in 1953 by General Motors; the other two were the Oldsmobile Fiesta and the Cadillac Eldorado. All three were limited production vehicles promoting General Motors’ design leadership. Of the three, the Skylark had the most successful production run with 1,690 produced. This was considered quite an amazing sales feat, for the car had a list price in 1953 of slightly in excess of US$5,000. All 1,690 regular-production Skylarks built in 1953 (and all in 1954) were convertibles. The 1953s were based on the 2-door Roadmaster, having identical dimensions (except height), almost identical convenience and appearance equipment, and a Roadmaster drive train. In 1953, the model designation for the Skylark was 76X, while the model designation for the Roadmaster convertible was 76R. The few options available to the Roadmaster convertible buyer were standard equipment to the Skylark buyer, albeit the base price for the well-equipped Roadmaster convertible was only about US$3,200.The 1953 Skylark featured V8 power and a 12 volt electrical system, both a first for Buick, as well as full-cutout wheel openings, a styling cue that would make its way to the main 1954 Buick line. Also making its way into the 1954 Buick line was the cut-down door at the base of the side window line that bounced back up to trace around the rear window (or convertible top). This styling clue stayed with Buick for many years and can be found on any number of automobile brands to this day.The 1953 Buick Skylark was a handmade car in many respects. The stampings for the hood, trunk lid and a portion of the convertible tub were the same as the 1953 Roadmaster convertible (and Super convertible, model 56R). The stampings for the front fenders, rear fenders, the outer doors, and a portion of the convertible tub were unique to the Skylark. All Skylark convertible tubs were finished with various amounts of lead filler. It is not unusual to find a substantial amount of lead filler just behind the doors near the bottom of the window line. The inner doors of the Skylark were made from the inner doors of the 2-door Roadmaster and Super by cutting the stamping in half approximately parallel with the ground and then welding the two pieces back together in a jig at an angle that produced the necessary door dip (see photos of finished car).Although there are many unique design features of the 1953 Buick Skylark, one that goes almost unnoticed today is that the top and seating of the car were lowered a few inches below the Roadmaster and Super convertibles. This was achieved not by changing the frame, body or suspension, but by cutting the windshield almost three inches shorter and lowering the side windows and convertible top frame. To accommodate people without bumping their heads with the top up, the seat frames and steering column were lowered.The wheels of the 1953 Buick Skylark were true wire wheels, produced by Kelsey-Hayes, with everything chromed save for the plated and painted “Skylark” center emblem. Although this was high style in 1953, the wheels were heavier than the regular steel wheels, would require periodic truing to keep them straight and balanced, and required tubes within the tires just when tubeless tires were becoming the norm, as they were throughout the rest of the Buick line.This car in particular was treated to a frame off restoration and has been carefully maintained since and is in beautiful show/concours condition. The car drives effortlessly down the road and always draws a crowd.